Phone Accessories origin question

Brand  phone manufacturers of spare parts for their products will be licensed to manufacturers in different regions to produce,Therefore with different models of  phone accessories on the origin will be different,but such cases will not affect the warranty of merchandise.

How to Correct charge

1.If you buy a new phone The first battery runs out  charge for the good The first charge is 8 ~10hours Please do not disconnect first three Charge as possible should be up to 10 hours
2.When the phone without electricity auto Shutdown,Automatic shutdown in case of charge This might lead you plug charger does not respond when This will reduce battery and phone the life So You should promptly charge.

How to use a new battery

new lithium-ion batteries are have electricity: the voltage is too low will affect its activity, and even give rise to protection circuits turn off the output lead to charge. If you receive the lithium-ion battery is low or even no electricity, then stored longer battery or self-discharge is too large.
New batteries at the factory with electric current of high-rate charge into polarization serious effects of bad energy, lithium-ion battery so the first three should be shut down at cell phone use natural (not repeated after the forced shutdown boot, may cause cell phone or battery protection, cutting off the output can not charge)card-ton recommendations use of  phones charger original charge around 6-8 hours.

☆ battery use common sense ☆:
1. Try not to set the phone Vibrating alert mode, power consumption too.
2. After charging the battery a few days, power has returned to natural wastage.
3. The more weak cell phone signal for use, the greater the power consumption.
4. In the use of the process, the metal battery contact surfaces shall be kept clean, otherwise it will reduce the capacity or the effects caused by interruption of the call.
5. All things will dispose of the battery in a fire, to guard against an explosion.
6. Do not use fake charger to prevent damage to the battery charge.
7. Batteries and keys and other metal objects should not be put together to prevent contacts on the battery, causing short-circuit.

How to avoid battery failure can not boot

In fact, can not boot most of the battery itself is not a problem, because batteries are in use, there have been charging and over-discharge, caused by the battery protection circuit, cutting off the output caused by the battery. Avoid prolonged charging of the batteries used in automatic shutdown to avoid repeatedly forced boot and timely charge is the key to avoid such questions.

Battery into the fridge to revive it?

Online tips have said let the battery back to life, as follows: put the battery wrapped with newspaper and then put into plastic bags, wrapped well Add freezer for three days (newspapers can absorb excess moisture); three days later took out two days at room temperature decentralization; two days will charge the battery, fully charged up after the phone into test (estimated to save 80% ~ 90%).
In fact, the method can only be frozen because of the individual active substances caused Overcharge battery loose generate the role of chance, while the open-circuit plate corrosion, aging active substances metamorphic transformation,card-ton Think they did not have any effect.

Answer the call when the echo phenomenon

From any telephone, including mobile phone, has a "side tone" of the problem:
At receiver heard their own voices. The reason is that phone calls are in the four lines: the transmitter and receiver of the two lines, but outside the system are second-line, mobile phone, too, must drive the need for second, four-lane conversion. Theoretically, if the "outside" of the impedance and machine "balanced network" exactly the same as the impedance, it does not produce the sound side. But the telephone line impedance of each user is different, phone balance network impedance can not be completely the same lines, and too complex balance network is not the economy, is impossible to eliminate the sound side. Mobile is also similar. As long as the size of the sound at the side to allow the scope, it is considered qualified.

phone maintenance and maintenance

1.card-ton.com The following recommendations help you to comply with the terms of maintenance, so that mobile phone can be used for many years. The use of mobile phones, batteries, chargers or accessories:
2. Will be mobile and their components and accessories on the kids not to touch places.
3. Maintain the cell phone dry. Precipitation, humidity and liquids contain minerals that will corrode electronic circuit boards.
 4. At not to have dust or clean place to use or storage of mobile phone, could undermine its removable parts.
5. phone not to be stored in hot areas. High temperatures can shorten the life span of electronic devices, damage batteries, and has written and warp or melt plastic parts.
6.  phone not to be stored in cold areas. When the temperature when the  phone,  phone will be the formation of moisture, and damage electronic circuit boards.
7. Do not try to open the cell phone. Non-professional staff to deal with the mobile handset will be damaged.
8. Do not drop, knock or shake the handset. Treatment of a cell phone will be the destruction of the internal circuit boards.
9. Do not use harsh chemicals, cleaning agents, or strong detergents to clean the cell phone.
10. If the mobile phone or any of its components is not working properly, will be taken to the nearest qualified repair body repair.

How to check card-ton mobile phones IMEI 

We provide each mobile phone  have An independent IMEI  Original query the same way Input * # 06 # Display IMEI 35.....

How to correct use the touch screen phone

1. If you feel not very agile touch suggest you to calibrate This allows a more agile touch
2.The correct operation of touch-screen Use of hand touch fingertips Click Do not use too much strength

How to protect metals and gold phone

Taboo: water,High temperature,Strong sunlight exposure Long time And any chemicals
1.If it is a good metal objects And Good processing manufacturing usually not easily rust appearance
2.When phone appear speck Please use the eraser Deal with,This will remove the Very easy,Please do not use the other approach